A switched-mode power supply (SMPS) works on a different principle. AC mains input is directly rectified without the use of a transformer, to obtain a DC voltage. This voltage is then sliced into small pieces by a high-speed electronic switch. The size of these slices grows larger as power output requirements increase. The input power slicing occurs at a very high speed (typically 10 kHz — 1 MHz). High frequency and high voltages in this first stage permit much smaller step down transformers than are in a linear power supply. After the transformer secondary, the AC is again rectified to DC. To keep output voltage constant, the power supply needs a sophisticated feedback controller to monitor current draw by the load. Modern switched-mode power supplies often include additional safety features such as the crowbar circuit to help protect the device and the user from harm.[1] In the event that an abnormal high amperage power draw is detected, the switched-mode supply can assume this is a direct short and will shut itself down before damage is done. For decades PC computer power supplies have also provided a power good signal to the motherboard which prevents operation when abnormal supply voltages are present.